HP Printer Error Code 0xc18a0106 cause due to Ink system failure also, re-starts does not work at that time. To Fix HP Printer Error Code 0xc18a0106, learn easy steps are given below by the HP Printer Support team.
Steps to Fix HP Printer Error Code 0xc18a0106
1: First disconnect your USB cable from your main device.
2: Before you disconnect the USB cable make sure you do not disconnect your printer.
3: Carefully remove the cartridges from your printer device.
4: Then wait until you get the control panel massage.
5: Carefully disconnect the power cables from your printer.
6: Leave your printer for 2 minutes.
7: After that reconnect all cables from your main device.
8: Before your reconnect, all cords, make sure to connect the cables properly.
9: Power turn on your device, if it will not turn it on automatically.
10: Reinsert your printer cartridge inside the printer and close if any doors open.
11: If you receive any print prompt on your device so, please do the same.
12: After that reconnect the USB cable to your main printer device and try to print something.
13: Users can try the System Configuration option as well.
14: Push and leave the ok key.
15: After that, you will get the hardware failure status.
16: If there is no option available on your device, then the user can follow the manual option as well.
17: Then leave the release key as it is.
18: Once you get the Hardware failure status then clear and press OK to clear the error.
19: Press and discharge the “Drop” catch the same number of times as vital, so that, either the “Welcome to Photosmart Express” screen shows up, or, the “Ink System Failure” screen shows up.
20: Try not to TRY TO PRINT at this stage.
HP Printer Support on Chat or Buy New One
21: Switch off your printer and remove the power cable from your main outlet.
22: Trust that the power will get released and after that plug the power link into the divider outlet first and afterward into the back of the printer.
23: On the off chance that the printer has just instated, go to the following stage. If not, the printer will begin the “One-time ink initialization process”.
24: Enable this procedure to finish and don’t intrude. When the installment procedure is finished, the printer will print out a diagnostic page.
25: To check printer usefulness print a self-test page. In the event that self-test prints, the printer is prepared for use or software installation.
After following all steps, if you are still unable to Fix HP Printer Error Code 0xc18a0106, I suggest you contact HP Support Service for further assistance by HP Printer Technical Support Number 1-800-576-9647. Our HP qualified technicians will give you the best solution for your concern.