HP Printer Error Code 11:11 is typically shown on the front board of your HP DesignJet Printer in light of the fact that a blame has been recognized with the trailing link. The trailing link is the segment that gives correspondence between the printer gadgets and the carriage PCA (Principal Component Analysis). To Fix HP Printer Error Code 11:11, read the below mentioned steps and get instant help.
Steps to Fix HP Printer Error Code 11:11
1: Turn it off your printer with the help of power button.
2: Disconnect the all power cable from the printer and outlet.
3: Then reconnect the all power cable and switch on your printer.
4: Also, remove the printheads, inks and papers from your printer tray and re-start the device.
5: After some time the trailing link on some HP DesignJet models can rub against the frame causing wear and inevitable disappointment.
6: On the off chance that the trailing link is noticeable on your printer, check for obvious indications of wear on the trailing link.
7: Some if the cases Error code 11:11 should be resolved by replacing the trailing cable as well.
8: Sometimes Error code 11:11 displayed due to failure of component which is attached to the trailing cord.
9: Before you replacing the trailing cable make sure, you have a proper knowledge about trailing cable.
10: Because it would be replaced only by experienced and qualified technician.
11: Trailing cable associates the carriage assembly to the Main PCA (Principal Component Analysis).
12: This will impart data to the carriage Assembly on when to print stream of ink onto the moving media.
13: Awful correspondence between the main PCA (Principal Component Analysis) and carriage assembly.
If the above steps not enough to Fix HP Printer Error Code 11:11, then please get in touch for further assistance by contacting the HP Printer support simply, dial our HP Printer Technical Support Number 1-800-576-9647 to get the expert advice.