HP Printer Error Code 47:01 is typically shown on the front board of your HP DesignJet Printer. This error occurs when there is an issue with the Starwheel Motor. The Starwheel Motor is utilized to raise the starwheel gathering when stacking media. In the event that the starwheel gets together can’t move, you will be notable utilize the printer. To Fix HP Printer Error Code 47.01, Connect with Printer Customer Support experts or Read the steps are mentioned below.
Steps to Fix HP Printer Error Code 47.01
1: Turn it off your printer with the help of a switch-off button.
2: Disconnect all power cables.
3: Reconnect all power cords and turn them on your printer.
4: Check for any unmistakable snags confining the development of the starwheel gets together.
5: Also, is to check the assembly cable not damaged or properly connected to your main device.
6: Also, scan and perform troubleshoot the further issue.
7: Try to replace the starwheel motor if it’s possible.
8: Also, It would like to share cleaning is not solution, it should be replaced.
9: It’s is right side of your device, behind the side cover of your printer device.
10: Make sure you have a piece of proper knowledge about motor replacement.
11: Otherwise you will be not able to replace the motor.
12: Once you replace properly then the printer has to be recalibrated with your device.
13: Wait for 1 to minutes after that reconnect the power cable.
14: Moreover also, is check there any paper stuck inside your printer or not.
Note: The majority of the solution and discussion issues can be settled by supplanting Starwheel Motor. Over a delayed time frame the starwheel engine can create ink defilement issues, fizzled engine and/or broken ringings and starwheel motor assembly will be replaced only by experienced and after replacing the starwheel motor if you still facing the issue.
You can also get in touch with us to Fix HP Printer Error Code 47.01. For that, you just need to call us at HP Printer Toll-Free Number 1-800-576-9647 and resolve your issue instantly.